1 amp Silent Running
Decoder, 2 Functions. White LEDs
$29.95
$24
$23
NCE
NIMFT-A
Intermountain
FT-A Plug and Play Decoder from NCE
$29.95
$24
$23
NCE
NIMFT-B
Intermountain
FT-B Plug and Play Decoder from NCE
$29.95
$24
$23
DTK
DCC Decoder Tester
The decoder tester is designed to easily test most DCC decoders.
Suitable for all scales.
$24.95
$20
* Trans =
Transponding is a feature in some Digitrax decoders to
"Transmit" the decoder address over LocoNet to a computer.
This feature works in conjunction with the Digitrax BDL-168 (Block Detector),
a transponding circuit board (RX-4) for the BDL-168 and WinLoc,
RR&Co, JMRI Panel Pro, or other software.
** BEMF = Back Electromotive Force is a
decoder feature that is best described as "Cruse Control" for your
locomotive. When set with 3 separate CV's (Configuration Variables) your
locomotive will attempt to maintain the speed you have set on your throttle up
grades, down grades and on a flat surface.
* The columns marked Orange and Gray indicate
where to solder the decoder motor wires so the "Forward and Reverse"
indicator on you throttle will report the proper direction. T=Top,
B=Bottom, F=Fireman's Side and E=Engineers Side.
