DCC Decoder Tester
The decoder tester is designed to easily test most DCC decoders.
Suitable for all scales.
$24.95
$20
Trans =
Transponding is a feature in some Digitrax decoders to
"Transmit" the decoder address over LocoNet to a computer.
This feature works in conjunction with the Digitrax BDL-168 (Block
Detector), a Transponding circuit board (RX-4) for the BDL-168 and WinLoc,
RR&Co, JMRI Panel Pro, or other software.
** BEMF = Back Electromotive Force is a
decoder feature that is best described as "Cruse Control" for your
locomotive. When set with 3 separate CV's (Configuration Variables) your
locomotive will attempt to maintain the speed you have set on your throttle up
grades, down grades and on a flat surface.
MSRP $58.95
High
current capacity wired decoder-for multi-motor HO or O locomotives or hard
wired multiple locomotive consists.
Features:
Scales: HO,
O and Lionel AC
FX3 Lighting Effects: Yes
Installation Type: Wired
Current (RMS): 4
Amp
Current (Peek): 6
Amps
Function Outputs: 6
@ .5 Amp each
Size Length: 2.04"
Size Width:
0.67"
Size Height: 0.11"
Addressing: 2
and 4 Digit
Consisting: Basic/Advanced
Decoder Reset: Yes
Speed Steps: 14,
28 and 128
Quiet Motor Mode: Yes
Add Sound (SFX064D): YES
Send mail tosales@sodigi.com with questions or comments about this web site.
